Avast WEBforum
Other => General Topics => Topic started by: Staind on September 12, 2005, 05:26:39 AM
-
Hi, I have just setup and configured my wireless network (which contains 1 desktop computer and 1 laptop - both using a wireless connection to connect to the internet). My question is - how can I set up the maximum possible security for the network and insure that it is actually running. Currently, I have setup WPA security, but I'm unsure if there is anything else I can do.
Suggestions, websites, and advice is appreciated since I am new to wirelessness!
-Staind
PS. I have just moved into my apartment, so I can start posting again!
-
I'm assuming you have a router ,you can enable MAC Filtering and only allow the MAC adresses of the 2 network cards you have to connect to the network(router).You can also disable SSID broadcast ;)
P.S:You could also tell us what your router brand is.
Mikey
-
You may also read about wireless here:
http://compnetworking.about.com/od/wireless/
-
The router I purchased is located here: http://www.amazon.com/exec/obidos/tg/detail/-/B0001D3K8A/104-2133461-1619110?v=glance
-
Nice router i have the older model of that one(it's the wrt54g without the speedbooster technology) ;D
So did you manage to set it up?
-
If you do a port scan and have ports shown as anything but stealth you can use port forwarding(at least that's what it's called in netgear) to stealth those ports.
-
Nice router i have the older model of that one(it's the wrt54g without the speedbooster technology) ;D
So did you manage to set it up?
Yea I managed to actually set it up - in terms of internet connection working etc, and I set up WPA. I'm just not sure if that's enough and how safe is file/print sharing.
-
Nice router i have the older model of that one(it's the wrt54g without the speedbooster technology) ;D
So did you manage to set it up?
Yea I managed to actually set it up - in terms of internet connection working etc, and I set up WPA. I'm just not sure if that's enough and how safe is file/print sharing.
Like i said try finding out the MAC adresses of the wireless cards, then enable MAC Filtering in your router(just enter the MAC adresses in the EDIT MAC Filter list and then select this one: Permit only PCs listed to access the wireless network)
I'll add my screenshot so you can see how i have it set up OK?
(http://img52.imageshack.us/img52/2940/macfilter8gg.jpg)
Also try going to the link i gave you if you have time...