By all accounts it is no longer a requirement to be connected as avast can repair using .vpu files in the setup folder. Unless of course the setup folder is missing files, in which case a reinstall would be required.
However if winXP Security Centre reports avast inactive, it could be a problem with the Security Centre WMI Repository, etc.
If you are running Windows XP, Service Pack 2 you can use a single command to detect and repair a corrupted WMI Repository. To do so, type the following from the command prompt (note that the parameter UpgradeRepository is case-sensitive and must be typed exactly as shown):
rundll32 wbemupgd, UpgradeRepository
After running UpgradeRepository you can verify the results by looking ay the Setup log. If inconsistencies are detected and if the operating system was able to rebuild the Repository you should see information in Setup.log similar to this:
(Wed Oct 12 13:46:36 2005): ===========================================================================
(Wed Oct 12 13:46:36 2005): Beginning WBEM Service Pack Installation
(Wed Oct 12 13:46:36 2005): Current build of wbemupgd.dll is 5.1.2600.2180 (xpsp_sp2_rtm.040803-2158)
(Wed Oct 12 13:46:36 2005): Current build of wbemcore.dll is 5.1.2600.2180 (xpsp_sp2_rtm.040803-2158)
(Wed Oct 12 13:46:52 2005): Inconsistent repository detected; it will be recreated
…
…
(Wed Oct 12 13:47:33 2005): Wbemupgd.dll Service Security upgrade succeeded (XP SP update).
(Wed Oct 12 13:47:33 2005): WBEM Service Pack Installation completed.
(Wed Oct 12 13:47:33 2005): ===========================================================================
(Wed Oct 12 13:46:36 2005): ===========================================================================
(Wed Oct 12 13:46:36 2005): Beginning WBEM Service Pack Installation
(Wed Oct 12 13:46:36 2005): Current build of wbemupgd.dll is 5.1.2600.2180 (xpsp_sp2_rtm.040803-2158)
(Wed Oct 12 13:46:36 2005): Current build of wbemcore.dll is 5.1.2600.2180 (xpsp_sp2_rtm.040803-2158)
(Wed Oct 12 13:46:52 2005): Inconsistent repository detected; it will be recreated
…
…
(Wed Oct 12 13:47:33 2005): Wbemupgd.dll Service Security upgrade succeeded (XP SP update).
(Wed Oct 12 13:47:33 2005): WBEM Service Pack Installation completed.
(Wed Oct 12 13:47:33 2005): ===========================================================================
/quote]
- OR
* Click Start, Run and type CMD.EXE
* Type this command and press Enter:
net stop winmgmt
* Using Windows Explorer, rename the folder %windir%\System32\Wbem\Repository. (For example, %windir%\System32\Wbem\Repository_bad.). %windir% represents the path to the Windows directory, which is typically C:\Windows.
* Switch to Command Prompt window, and type the following and press ENTER after each line:
net start winmgmt
EXIT
Reboot
Traduction en Francais:
Maintenant, il n'est plus nécessaire d'être connecté vu qu'Avast peut faire une reparation en utilisant les fichiers .Vpu dans le répertoire d'installation. À moins bien sûr qu'il manque des fichiers dans le dossier d'installation. Le cas echeant, une réinstallation sera nécessaire.
Toutefois, si le Centre de Sécurité WinXP montre qu'Avast est inactif, cela pourrait être un problème avec le Centre de sécurité WMI Repository, ou autre.
Si vous utilisez Windows XP, Service Pack 2, vous pouvez utiliser une commande simple pour détecter et réparer un référentiel WMI corrompu. Pour ce faire, tapez la commande suivante à partir de l'invite de commande (notez que le paramètre UpgradeRepository est sensible à la frappe et doit être dactylographié exactement comme montré):
Rundll32 wbemupgd, UpgradeRepository
Après l'exécution de UpgradeRepository vous pouvez vérifier les résultats de la recherche dans le log de l'installation. Si des incohérences sont détectées et que le système d'exploitation a été en mesure de reconstruire le référentiel, vous devriez voir l'information dans le Setup.log similaire à ceci:
(Wed Oct 12 13:46:36 2005): ===========================================================================
(Wed Oct 12 13:46:36 2005): Beginning WBEM Service Pack Installation
(Wed Oct 12 13:46:36 2005): Current build of wbemupgd.dll is 5.1.2600.2180 (xpsp_sp2_rtm.040803-2158)
(Wed Oct 12 13:46:36 2005): Current build of wbemcore.dll is 5.1.2600.2180 (xpsp_sp2_rtm.040803-2158)
(Wed Oct 12 13:46:52 2005): Inconsistent repository detected; it will be recreated
…
…
(Wed Oct 12 13:47:33 2005): Wbemupgd.dll Service Security upgrade succeeded (XP SP update).
(Wed Oct 12 13:47:33 2005): WBEM Service Pack Installation completed.
(Wed Oct 12 13:47:33 2005): ===========================================================================
Note: Il y aura probablement d'autres entrées dans le journal, mais vous devriez recherche en particulier celles qui sont affichées ci-dessus.
Autre possibilitees:
* Click sur Demarer, Execute et taper CMD.EXE
* Taper cette commande et presser Entree:
net stop winmgmt
* Utiliser Windows Explorer, et renommer le fichier %windir%\System32\Wbem\Repository. (For example, %windir%\System32\Wbem\Repository_bad.). %windir%
Représente le chemin vers le répertoire Windows, ce qui est généralement C:\Windows.
* Passer à la fenêtre d'invite de commande et tapez la commande suivante, puis appuyez sur ENTRÉE après chaque ligne:
net start winmgmt
EXIT
Reboot