HIGH CPU TEMPS w/ FULL SCAN
just one thing: could you please do something about manual scan resources, when not using the persistence cache, ie a first full scan, because no matter how you set the priority (normal, low,high), it uses an awful lot of CPU, especially during the scanning of the Winsxs folder and the CPU is getting really hot, too hot, and too long; not good, especially in laptops where ventilation is generally average. I got the same problem every time I reinstall AIS; tried to keep the persistence cache from the previous install but it looks like they can't be reused. Anyway, I don't even want to take the persistence cache feature into account, one should be able to do a full scan in "low priority" mode without a problem and keep using the system normally. This was absolutely possible with Avast 4.8, why not in V5?
See attached pic (not from today but it happened again today after for some reasons not related to this post, I needed to reinstall, and do a full scan again). Adding, that again, at the contrary of V4.8, low, high or normal priority for a scan doesn't seem to make any difference in V5, it's always stuck (not in the GUI) on high. When I decide to run a full scan, I don't care how long it takes, all I want is that it would really run in "low priority".
edit: I'm alsmost sure I mentioned this problem already during the beta testing, and that was solved, ie low priority worked as expected in new builds, ie on low priority, so this sounds now like a regression, since 418.