« previous next »
Pages: [1]   Go Down

Author Topic: Behavior shield awfully quiet  (Read 2497 times)

0 Members and 1 Guest are viewing this topic.

street_lethal

  • Guest
Behavior shield awfully quiet
« on: February 23, 2011, 09:38:43 PM »
Updated to the official v6 release from the RC on my Win 7 x64 system. The behavior shield is awfully quiet, 0 events analyzed. I assume this is normal?
Logged

derry

  • Guest
Re: Behavior shield awfully quiet
« Reply #1 on: February 23, 2011, 09:43:32 PM »
You can go into the settings and teak it to set to *ask* then it will be more chatty but stalk installation is best.
Logged

street_lethal

  • Guest
Re: Behavior shield awfully quiet
« Reply #2 on: February 23, 2011, 10:07:03 PM »
It's much more active on my XP system than on my Win 7 x64 system.
Logged

YoKenny

  • Guest
Re: Behavior shield awfully quiet
« Reply #3 on: February 23, 2011, 10:54:33 PM »
Its very active on my Win 7 x64 system.
« Last Edit: February 23, 2011, 10:56:13 PM by YoKenny »
Logged

street_lethal

  • Guest
Re: Behavior shield awfully quiet
« Reply #4 on: February 23, 2011, 11:30:07 PM »
I'll keep an eye on it and see what happens, it's analyzed some stuff but not much. I also don't do much on the system to be honest.
Logged

street_lethal

  • Guest
Re: Behavior shield awfully quiet
« Reply #5 on: February 24, 2011, 06:03:53 PM »
When I updated from Avast 5.1.889 to 6.0.992 RC early yesterday the behavior shield was active. When I went from 6.0.992 to the final 6.0.1000 via the GUI the behavior shield stopped scanning. Anyway, I uninstalled Avast again today and did a clean install of 6.0.1000 and all is well, the behavior shield is active again. I knew something was up. This time I did a custom install and unchecked the gadget and the webrep plugin, not because they were causing issues, I just have no interest in them.
« Last Edit: February 24, 2011, 06:05:42 PM by street_lethal »
Logged
Pages: [1]   Go Up
« previous next »